No controls. No wires. No compromise. It seems impossible until it is done. The ArtoAmp 150 is the future of music at home. Connectivity to portable devices with up to 16 Bluetooth inputs plus three standard inputs via cables. Beneath its slim exterior the performance is as much cutting edge as the new simplicity. Less is More is assured by up to 2 x 150 watts power with a purity of   -100dB silence between the notes.

Specifications:
Power output: 75 watts per channel into 8 Ohm
150 watts per channel into 4 Ohm
Power bandwidth: 5 Hz to 50 kHz (- 3dB)
3 Line level inputs via rca sockets
16 wireless inputs via Bluetooth
Input sensitivity: 1 V
Input impedance: 47 kOhm
Hum and noise: Typical noise level: -100dBA ref. 75W in 8 Ohm
Total harmonic distortion: 0,01%
Power supply: 2 x toroidal transformers
Dimensions: 305 x 305 x 60 mm
Weight: 7 Kg net.

See the manual for ArtoAmp 150 here.

At Artora we believe strongly in the mantra Less Is More – in fact so much that we have made it into the control section of every Artora product. With those three words, printed discretely on top of the units, you control the ArtoPlayer 1000 or the ArtoAmp 150. Touch LESS and you turn down the volume on the amplifier or go to the previous track on the disc. Touch MORE and you increase volume or go to the next track. IS lets you select the operating mode of the unit. Clean and simple thinking.

The ArtoAir lets you play music from your iPod to the ArtoAmp 150 via Bluetooth.
Imagine this: No more cables, no more docking stations – it’s all in the air.
You can play all your music wirelessly. Just plug in the ArtoAir into your iPod and the little receiver in the ArtoPlayer 150 will convert the signal to play the music wirelessly.
And of course you can pair your mobile phone or your computer to the ArtoAmp 150 too, if that is where you keep your music.

The ArtoRemote adds the finishing touch to the Artora Stereo System. Using the same soft touch technique found on the ArtoPlayer 1000 and the ArtoAmp 150 you can control all of the functions by gently pressing one of the icons on top of the remote. In order to make it as simple as possible we’ve limited the functions on the remote to those few functions we’ve deemed necessary to control the system. No weird functions on the ArtoRemote – just what everybody needs to make the system perform: Play, Pause, Next track, Previous track, Volume Up and Volume Down etc. And as a little special feature – press the Artora logo at the bottom of the remote in order to toggle between the different inputs on the ArtoAmp 150. The ArtoRemote comes in a high quality polished aluminum finish and has a size and weight that makes it a sheer pleasure to handle.

The ArtoPlayer 1000 is the end result of countless hours of experimentation, fine-tuning and a relentless dedication to sonic perfection.
Immediately you will notice the lack of buttons and switches. A sleek, innovative design with only the words ‘LESS IS MORE’ discretely printed on top of the cabinet. These three touch sensitive words control all functions of the player. Touch MORE to select next track on the disc or LESS to select the previous track. Touching IS gives access to more functions.
The perfect exterior is a constant reminder of the craftsmanship within.

Specifications:

Frequency response: 5 Hz – 20 kHz +/- 0,3 dB
Signal to noise ratio: Better than 100 dB
THD: Less than 0,002% at 1 kHz
Dynamic range: Better than 95 dB
Phase linearity: Better than 0,3 degrees
Channel saparation: Better than 90 dB
Analog output: 2 V RMS
D/A Converters: Burr-Brown 24 bit, 192 kHz
Dimensions: 305 x 305 x 60 mm
Weight: 4 Kg. net

See the manual for ArtoPlayer 1000 here.